Introduction：
Remove large particles of exhaust gas with aerosol spray or filter material before treating the exhaust gas, and then treat the harmful gas components of VOC；There are the following treatment options:
classify： ActivatedCarbonAdsorption  UV Photodissociation and Activated Carbon、 catalytic combustion 、RTO
The principle of some processing methods is as follows：
1、Condensing recovery method：pretreatment  Chemical potions are used more frequently。
2、adsorption method ：
(1)Direct adsorption method：The adsorption rate of organic waste gas by activated carbon can reach more than 95%, the equipment is simple and the investment is small, but the activated carbon is replaced frequently, and the working procedures such as loading and unloading, transportation and replacement are increased, which leads to the increase of operating cost.
(2)adsorption recovery method：adsorbing the organic waste gas with fiber active carbon , performing desorption regeneration after being close to saturation with superheated steam ; and the method has the requirement of providing the necessary steam amount .
(3)Adsorption catalytic combustion: This method integrates the advantages of adsorption method and catalytic combustion method. A new adsorption material (honeycomb activated carbon) is used to adsorb and desorb with hot air. After desorption the waste gas is introduced into the catalytic combustion bed without flame and thoroughly purified. The heat gas is recycled in the system and the energy consumption is greatly reduced. This method has the advantages of stable operation low investment and low operating cost. It is suitable for the treatment of waste gas with large air volume and low concentration. It is a mature and practical method for the treatment of organic waste gas in China at present.
Widely used in automotive 3 C / T, electric vehicles, home appliances, hardware, plastics, machinery and other coated waste gas treatment.